![]() ![]() Plug the device back in and turn the power on.Check to verify that the remote control sends an infrared signal.Insert new batteries, noting the correct polarity.Press each button on the remote control twice to discharge the power.Remove the batteries from the remote control.Make sure the IR sensor on the device isn't exposed to direct sunlight or bright lights.Move indoor plants and devices that may cause interference.Open glass doors to determine if that makes a difference. Glass doors or enclosures can affect the signal from the remote control.Remove any objects that may block the IR signal between your remote control and the device.Review the short tutorial or skip to the steps below. If you need model-specific information, check your Make sure you are within 3-10 feet of your device and pointing the remote control at the IR sensor of the device.Ĭheck the remote control after each step to determine if it is working.Press the power button directly on the device, not the remote control. Make sure the device to be controlled is on and functional. ![]() A damaged remote control should be replaced. An IR-mark identifies a infrared remote control and is usually located at the bottom part of the remote control, near the model number. The following are general troubleshooting steps that address most of the issues with an infrared (IR) remote control. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |